FAAC H4, Installation And Use Instructions Manual, Page: 20 / 36

20
„ „
Warning signal test
- Press the control unit's TEST push-button.
Everyone of the system's warning signal emits a
brief beep in succession, and then the control unit
beeps once.
AP EFF TEST
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
„ „
Outdoor siren test
While holding down the self-protection contact,
- Press the siren's TEST push-button.
The control unit emits a beep.
SYSTEM TEST
The control unit must be in MAINTENANCE
PROGRAM mode
We advise you to run the test so that you can verify -
after installation - if all the elements of your alarm
system are operating correctly.
For security reasons, the test should be run whenever
a device is added, before a long period of absence
and, in any event, regularly.
„ „
Remote-control test
When the ON or OFF keys of the remote-control are
pressed, this should cause the confirmation signals
to be emitted by the control unit (refer also to the
switch configuration).
BeeP
BeeP
-
+
OK
INFO C
-
+
OK
INFO C
OK OK
INFO INFO
„ „
Test of control and information keypad
- Press the key.
The display shows “ -- -- -- -- ”.
- Press the key.
The control unit and keypad emit a beep.
INFO INFO
OK OK
„ „
Detector test
- Press the detector's TEST push-button.
The control unit and detector beep once.
The detectors are in TEST mode and beep once at
every detection, in the case of movement detectors,
and at every opening of a passage, in the case of
opening detectors.