FAAC H4, Installation And Use Instructions Manual, Page: 30 / 36

30
OPERATION OF TELEPHONE CALLS
DURING AN ALARM
„ „
Events sending
The telephone transmitter element makes calls on
the switched telephone network (STN), according to
the following principle:
- a telephone call to recipients according to a preset
cycle (see paragraph telephone calls Cycle). When a
recipient answers, it asks him/her to press a key to
continue listening, and sends a pre-recorded
welcome message.
- indication of the type of event, date and time,
- indication of the suggestions to re-listen to the
welcome message, to listen to the protected room, or
to speak via the transmitter for about thirty seconds.
- event confirmation request, by pressing a key,
- manual disconnection by pressing a series of keys
or automatic.
„ „
Telephone calls cycle
Every alarm trips a cycle of telephone calls, which
entails several attempts in sequence, as shown at
the side here.
The transmitter exits the cycle as soon as:
- the call reception confirmation code (push-button
4) is received, or when the cycle has been performed
4 times (for numbers 1, 2 and 3) and 3 times (for
number 4), or
- an order was issued (disable or enable) with a
system control device (remote-control or keypad).
An alarm
is tripped
1
st
number called
Alarm ON / Alarm OFF Maintenance Program mode 2 secs.
Alarm memory-stored / In progress System sabotage alarm
Discharged batteries Peripheral units fault /
Telephone line fault
Passage open signal
The transmitter calls
via the telephone
network, according to
a defined cycle
4
th
number called, if
necessary
The telephone call
sequence begins
(following an alarm)
End of
telephone
calls
sequence
The telephone transmitter holds the line
engaged for the entire duration of the cycle.
5 seconds
5 seconds
5 seconds
5 seconds 5 seconds
telephone call number 1
telephone call number 2
telephone call number 3
telephone call number 4
5 seconds
HOW AN ALARM TAKES PLACE
6