FAAC H4, Installation And Use Instructions Manual, Page: 12 / 36

12
PROGRAMMING
3
-
+
OK
INFO
C
GO TO ADD DEVICES MODE
When purchased, the control unit is not
programmed.
To ensure that the control unit recognises the
system's elements, it must be made to 'learn' them
(registration of the devices).
When the control unit is powered up, its indicator
lights flash rapidly and, then, the red indicator lights
flash simultaneously but more slowly. The control unit
is in Maintenance Program mode (the yellow warning
light flashes every second).
Learning of the control keypad
The keypad must be powered.
- Press and, then, using a pointed objective (e.g.
pencil), press the configuration access push-button
located under
key of the keypad.
The yellow indicator light comes on with steady
beam: this means that the control unit is in ADD
DEVICES menu.
OK OK
AP
EFF
TEST
+
+
+
-
-
+
-
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
Learning of a MASTER remote-control
The MASTER remote-control must be the first
remote-control to be programmed.
In fact, the Master remote-control is essential for
adding any other remote-control.
Time to carry out this operation is limited.
Procedure
-Press the future ON key for 10 seconds: the control
unit beeps once and goes into Add Devices menu.
The yellow operation indicator light comes on with
steady beam.
-Simultaneously press push-buttons 1 and 2 until the
remote-control starts to flash.
-Press the ON Key once:
the control unit beeps once.
-Simultaneously press push-buttons 1 and 2, until
the remote-control begins to flash and, then, press
OFF:
the control unit beeps twice.
-Press the ON key twice in succession: the control
unit should emit a confirming beep. The remote-
control indicator light stays lighted on steady beam
for as long as pressure is exerted.
-Press the OFF key twice in succession: the control
unit should emit two confirming beeps.
The control unit has registered the master remote-
control.
THE CONTROL UNIT IS IN ADD DEVICES MENU.
The yellow indicator light stays lighted.
1
2
ON
BeeP
AP EFF TEST
2 secs.
Passage open signal
Peripheral units fault /
Telephone line fault
Discharged batteries
System sabotage alarm
Alarm memory-stored / In progress
Maintenance Program mode
Alarm ON / Alarm OFF
At this point the control unit waits for a control
device to be registered.
Proceed, using a control keypad or a remote-
control.
C