16
Technical block
When you consult the telephone transmitter, a
“Technical block” message will be shown in one of
the following cases:
- the transmitter's identity was deleted by a system,
- the control unit battery compartment is open
(maintenance program mode).
Communication block
When an alarm is in progress, the telephone call in
progress
cannot
be blocked (a call from the
transmitter to the outside).
To interrupt the current telephone call cycle, press
the OFF key of a remote-control.
ACCESS TO THE TELEPHONE
TRANSMITTER
Method 1:
From a different telephone line - mobile or fixed -
type in the number of the system.
The transmission control unit engages the line after
5 to 10 ring tones.
Method 2:
To be used when the transmission control unit co-
exists with a telephone answering system or other
automatically enabled equipment.
The control unit must be in MAINTENANCE
PROGRAM mode
(See Alarm Control Unit
Instructions).
Wait for 1-2 ring tones
"Tuu"
Wait for 5-10 ring tones
"Tuu"
The transmitter answers
Method 1
Method 2
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
Hang up and wait for 10 seconds
Type in the system's number again
The transmitter answers after 1 or 2
ring tones
Type in the number of the system from an
external line
Type in the number of the system from an
external line
Hello, please type in the access code
Hello, please type in the access code
CUSTOMISING THE SYSTEM
4
Summary of Contents for H4
Page 2: ...2...