Standard System
Overview and Safety Zones
The system display to the below is a recom-
mended standard system. Other approved
accessories can be installed. Photo sensors
and a flashing light indicating gate move-
ment is recommended for safety purposes.
IMPORTANT
Preliminary Checks:
To ensure safety and an efficiently operating automated system, make sure the following condi-
tions are observed.
The gate and post must be suitable for being automated. Check that the structure is sufficiently
strong and rigid, and its dimensions and weights conform to those
indicated on page 1.
Make sure the leaves move smoothly without any irregular friction during entire travel.
Make sure the hinges are in good condition. Ball bearing hinges are ideal for gates weighing
over 200 lbs. or over 10’ in length.
Make sure the gate is plumb and level.
The fence post must be secured in the ground with concrete. This will prevent
alteration of alignments and leveling during installation and during cycles.
1.3
1,2
Estate Swing Operator
3
Photocells (not included)
4
Control board
5
N/A
6
Push button opening device (not included)
7
Receiver extension (not included)
8
12Vdc flashing lamp (not included)
9
Positive stop
10
DC transformer
Notes:
1) When laying electrical cables, use appropriate rigid and/or
flexible tube.
2) Do not run any wires in the same conduit as 110 AC
power that may be in the area. This will cause unwanted
interference.
