5.4
Estate Swing 433 Plug-in Receiver (cont.)
5. Plug the red clip inside the control box into the
control board. The groove in the red clips should snap
into the guide on the 5 prong connector. (
Fig 1
)
6. The red power light should come on the receiver.
(
Fig 2
)
7. Program your remotes to the receiver:
A.
Press and release the LEARN1 button at the top of
the receiver board (ex 1). The learn LED will illumi-
nate steady (ex 2). (
Fig 3
)
B.
Press and hold the button on the remote you wish
to program to the receiver.
C.
Hold the remote button until the Learn LED flash-
es and then turns off. (caution your gate opener may
be triggered during this process)
D.
Repeat A through C for all additional remotes.
Fig. 1
Fig. 2
Fig. 3
NOTES ABOUT REMOTES:
You can program up to 400 codes into the receiver. This
could mean 1 button on 400 different remotes or this could
mean all 4 buttons on 100 remotes or anything in between.
Some choose to program all 4 buttons to a single receiver if
they are not using multiple gates to eliminate pressing the
incorrect button on the remote. To do so follow the pro-
gramming above with each button of the remote. You can
erase all programmed codes by holding Learn 1 until the
Learn LED comes ON and then turns OFF.
8. Put the cover on the receiver and secure it in place using
the provided screw.
IMPORTANT:
The receiver is a drip proof receiver. This means that it is designed to
prevent water from accessing the inside of the receiver when the water is moving downward
with gravity (rain for example).
DO NOT
mount the r eceiver anyplace that water may access it from another angle.
For example: Do not mount near sprinklers. Do not mount the receiver horizontally. Do not
mount the receiver near a flat surface where water could splash upwards.
