Setting Closed Limit Switch - Pull-to-Open
4.3
1. Insert limit buzzer. Place the bare end of the limit buzzer wire into the Limit1 CL1 terminal. Attach
the alligator clip from the other lead of the buzzer to the bare tip of the small black wire from the op-
erator arm.
2. Apply power to the circuit board as
previous seen in the instructions.
The buzzer should be sounding un-
less already on the closed limit
switch.
3. Manually release the operator arm
and slowly move the gate from the
open position to the closed position.
If the buzzer stops and starts again
while moving to this position make
note of this for the next step. Once
the gate is in your desired closed
position you are ready to adjust the
limit switch.
4. If the buzzer had turned off and
back on while moving the gate
closed: Turn the FCC screw clock-
wise until the buzzer stops.
If the buzzer did not turn off and
back on while moving the gate
open: Turn the FCC screw counter-
clockwise until the buzzer stops.
5. Your limit is now set for the open
position and you can remove the
buzzer and put the black wire direct-
