5. Temporarily
position the gate side
mounting bracket.
(horizontal position
does not matter, vertical position on the
gate is the position you are matching to
the post bracket.)
Position your assem-
bled gate mounting along the previously
drawn vertical line and level the angled
piece with the horizontal piece of the gate
mounting bracket using a level. Mark your
holes, drill and attach the brackets using
4) 3/8” carriage bolts.
6.
Assemble the rear fitting to the operator as shown below.
7.
Run
the 5
wires from the arm(s) to the control board as seen in section 3.
8.
Set the operator for manual operation. And extend the operator arm slightly past the full
retracted position..
2.10
