E145
36
732784 - Rev. A
OK
>5””
OK
OPEN A
OPEN B
>5”
>5”
ENGLISH
6.2.1 REMOTE MEMORISATION OF
LC/RC
RADIO CONTROLS
With
LC/RC
radio controls you can remotely memorise other radio controls, i.e. without working directly
on the board, using a previously memorised radio control.
1. Take a radio control that has already been memorised on one of the 2 channels (OPEN A or OPEN
B/CLOSE) and move to the vicinity of the board.
2. Simultaneously press and hold P1 and P2 until both LEDs flash slowly for 5 sec.
3. Within 5 seconds, press the previously memorised radio control button to activate the learning phase
for the selected channel.
4. The LED on the board corresponding to the channel in learning mode will flash for 20 sec within which
another radio control code is transmitted by pressing the button.
5. The corresponding LED on the board will go on steady for 2 sec (indicating that memorisation has
been completed) and will begin flashing again for another 20 sec, during which you can memorise
other radio controls, and will finally go off.
6.3 MEMORISING
DS
RADIO CONTROLS
1. On the
DS
radio control, choose the desired ON - OFF combination of the 12 dip-switches.
2. Press and hold +/R1 - SW1 (OPEN A programming) or -/R2 - SW2 (OPEN B/CLOSE programming).
3. After keeping the button pressed for about 5 sec, the corresponding radio LED (DL11 or DL12) will
begin to flash slowly for about 20 sec.
4. Release the button.
5. During radio LED flashing, press the button of the radio control you wish to program.
6. The corresponding LED on the board (DL11 or DL12) will go on steady for 1 second and then go off,
indicating that memorisation has been completed.
7. To add other different codes, repeat the procedure starting from point 1.
8. To add other radio controls with the same code, set the 12 dip-switches according to the same com-
bination as the already memorised radio control.
OPEN A
TOTAL OPENING
OPEN B
PARTIAL OPENING
DESIRED
CODE
DESIRED
CODE
