![background image](http://html1.mh-extra.com/html/faac/e145/e145_manual_3097771028.webp)
E145
28
732784 - Rev. A
ENGLISH
Display
Advanced Function
Default
C
C
X-COM RADIO MODULE RESET and ACQUISITION
:
The
X-COM
module is used for radio communication between the boards
and the PC/MAC. Before enabling communication, the
X-COM
module must
be configured.
Y
X-COM
module is configured and is ready for operation.
Press and hold the
-
button for 5 sec it is possible to reset the
X-COM
module.
no
no
X-COM
module is inserted and configured.
To begin the configuration procedure is necessary
to insert the module in connector M1A-
X-COM
located on
the board and hold the
+
button for 5 sec.
On the display will appear
Y
and the flashing light will be activated.
Then the configuration procedure must be completed using a PC/MAC.
no
AS
MAINTENANCE REQUEST - CYCLE COUNTER (linked to the subsequent
two functions
):
You can enable the signaling of maintenance request, or the cycle counter.
Y
= enable the SIGNALING when the programmed number of cycles has
been reached (as defined in subsequent two functions
nc
and
nd
).
Signaling consists of a pre-flashing of 8 sec (in addition to the time
may already be set with the function
PF
) before each movement.
If using a PC/MAC a maintenance request is set with a number of
cycles greater than 99,990, the subsequent two functions
nc
and
nd
will display 99 and 99, respectively.
no
= enable the CYCLE COUNTER, that will be displayed in the subse-
quent two functions
nc
and
nd
up to a displayed maximum of 99,990.
If the number of cycles performed is greater than 99,990 the subse-
quent two functions
nc
and
nd
will display 99 and 99, respectively.
no
nc
CYCLE PROGRAMMING (THOUSANDS
):
If
AS
=
Y
the display will show the number of thousands of cycles after which
the signaling of maintenance request begins (can be set from
0
to
99
).
If
AS
=
no
the display will show the number of thousands of work cycles
performed. The value displayed is updated with the succession of the cycles,
interacting with the value in
nd
.
When
AS
=
no
you can reset the cycle counter: press simultaneously
+
and - for 5 sec.
00