E124S 14
532434 - Rev.A
Tr
ansla
tion of the orig
inal instruc
tions
ENGLISH
XF OR XF FDS MODULE
XF FDS / XF
(3 pin)
Insert the XF Module into the 3-pin quick insertion
connector. Insert it as shown in the figure.
RADIO RECEIVER/DECODER BOARD
RADIO (5 pin)
Insert the radio receiver board or the decoder board
into the 5-pin quick insertion connector. Insert it as
shown in the figure.
L
If a FAAC RP receiver is used, it is recommended to install
the appropriate external antenna in order to obtain a
sufficient range (see the device instructions).
EMERGENCY BATTERIES (
BATTERY
)
Connect the back-up batteries (dedicated section in
the § Accessories chapter) or a stabilized power supply
top the
BATTERY
connector.
L
Connect before switching on mains power.
MAINS POWER SUPPLY (
CON
)
N
L
PE N L
CON
Connect the mains power supply to the
CON
terminal
board on the switching power supply.
Use at least 3G 1.5 mm2 wires.
!
It is mandatory to connect to the system earthing
conductor.
L
The switching power supply is factory set to a mains
voltage of 230 V~ and is connected to the
POWER
con-
nector on the board. If the mains voltage is 115 V~,
the position of the selector (Switching power supply)
has to be changed.