24
ENGLISH
6A ADJUSTING THE CLOSING MECHANICAL STOPS
(DOUBLE LEAF)
The automatic door is supplied with the closing mechanical stops
installed on the mid-point of the support profile. If the door centre
requires adjustment, proceed as follows:
• Check if the mechanical stops are at the centre of the profile.
• Take the leaf or leaves into the closing position.
• Loosen the
the 2 screws 10mm of the carriages (Fig.36 ref.
).
• Take the carriage close to the contact point until the two
touch.
• Tighten again the
Tighten again the 2 screws 10mm securing the carriages.
securing the carriages.
• Place and secure the closing mechanical stops of the
external leaves (fig. 36 ref.
) with internal leaves at closure
against the stop limit (fig. 36 ref.
).
6.1A
ADJUSTING THE CLOSING MECHANICAL STOPS (SINGLE
LEAF)
The automatic door is supplied with the closing mechanical stops
installed on the support profile. As the leaves close, make sure
that the carriages come into contact with the mechanical stops.
Place and secure the closing mechanical stops of the external
leaves.
fig. 36
