Standalone
MediaPort 200
Application Setup
The MediaPort 200 can integrate seamlessly into a variety of applications. This section
contains instructions on how to set up the MediaPort 200 for the following application:
•
— Standalone MediaPort 200
This application is one of many configurations for the Standalone MediaPort and was
designed to give a fundamental understanding of the MediaPort 200 in a common
application.
Overview
This section contains a general discussion of MediaPort 200 inputs and outputs and
their intended uses when the MediaPort is 200 is used as a standalone device. All of the
principles described here are used in the application setup procedure that follows.
NOTE:
Ensure the MediaPort 200 is set to Standalone audio mode in PCS before
on page 59 for more information about
selecting Standalone audio mode).
Video Input and Output
HDMI Input
The HDMI Input can be fed from a camera, a computer, HDMI switcher, or other HDMI
source. The HDMI source can be a video conference or document camera without audio.
The source can also be a PC or switcher output that includes embedded audio. If the HDMI
input includes microphone audio, the HDMI audio should be muted.
HDCP-Compliant HDMI Loop-Out
The HDCP-Compliant Loop-Out can be used as a local monitor output or can be fed into
a hardware video codec. If required, adjust the HDCP output settings via PCS (see
on page 42), the front panel (see
or
SIS Commands (see
HDCP Authorized — Input Reporting as an HDCP Authorized
MediaPort 200 • Standalone Application Setup
83
