Extron electronics mediaport 200, User Manual

Page: 87 / 164

Front Panel Lockout (Executive Mode)
To prevent accidental changes to settings, the MediaPort 200 front panel controls can be
locked by placing the unit in lock (executive) mode. While the MediaPort is in lock mode,
Ethernet, RS-232, and USB communication remain available, as well as the ability to exit
lock mode. The front panel lock setting is retained after a power cycle.
• To enable Executive Mode , press and hold the
Menu
and
Next
buttons
simultaneously until
Executive Mode Enabled
appears on the LCD screen
(approximately 5 seconds). This same message is displayed any time a front button is
pressed or a knob is rotated.
• To disable Executive Mode, press and hold the
Menu
and
Next
buttons until
Executive Mode Disabled
appears in the LCD window (approximately 5 seconds).
Lock mode also can be enabled and disabled via SIS commands (see Front Panel Lock
(Executive Mode) on page 130).
Resetting
Resetting the unit causes various settings to revert to factory defaults. Three methods of
resetting the MediaPort 200 are available:
• Reset Button — There are three reset modes (numbered 1, 4, and 5 for the sake
of comparison with Extron IP Link products) that are available by pressing the
Reset
button on the rear panel. This button is recessed, so a pointed stylus, ballpoint pen, or
small screwdriver (such as the provided Extron Tweeker) must be used to press it the
appropriate number of times. The
Reset Modes Summary table on the next page
provides an explanation of each reset mode.
•
Front Panel Menus
— To reset the MediaPort to its factory settings but retain the
current firmware version, press the front panel buttons as follows:
1. Press
Menu
repeatedly until the
Advanced Configuration
menu is displayed on
the LCD screen.
2. Press the
Next
button until
Factory Reset
is displayed.
3. Rotate either
Adjust
knob to display
<Yes>
or
<No>
.
4.
Press
Next
. The LCD screen displays
Press Next for Factory Reset
.
5. Press
Next
again to start the reset.
•
While the reset is in process, the screen displays
Factory Reset Please Wait
.
Do not use any front panel buttons or knobs until the reset is done.
•
When the reset is complete,
Extron MediaPort 200
is displayed for
30 seconds, followed by the default cycle.
•
SIS Commands
— Five types of reset are available via SIS commands (see
Reset
on
page 132):
•
Erase all user EDID files from flash memory.
•
Reset all device settings to factory defaults except IP and user files (items that are
reset are device-dependent).
•
Perform absolute reset but retain IP settings.
•
Reset all device settings to factory defaults but retain current firmware version.
•
Reset only IP settings to factory defaults.
MediaPort 200 • Front Panel Operation 80