Extron electronics mediaport 200, User Manual

Page: 93 / 164

Standalone MediaPort 200
Application Setup Example
Application 1 — Standalone MediaPort 200
NOTE:
Ensure the MediaPort 200 is set to Standalone audio mode in PCS before
beginning setup (see General Settings Tab on page 59 for more information about
selecting Standalone audio mode).
This is an application for soft codec conferencing, in which the MediaPort 200 operates as a
standalone device.
MediaPort 200
100-240V - - A MAX
50/60 Hz
HDMI
LOOP OUT
MIC/LINE
+48V
LINE L R LINE L R
REMOTE OUTPUT
LAN
USB
REF AUX
RESET
RS-232 +12V
I/O
Tx
0.1A
MAX
Rx G
I1 I2 G O1 O2
INPUT
iPod 9:45 AM
• P H U S •
POWER STANDBY
Table Microphone
iPod Camera
PC
Audio
Video/Audio
MediaPort 200
XPA 1002
XPA 1002
1 2
LIMITER/PROTECT
SIGNAL
OVER
TEMP
Figure 77. Application 1 — Standalone MediaPort 200 for Soft Codec Conferencing
To set up Application 1:
1. Connect an HDMI source to the MediaPort HDMI input. Figure 77 above shows an
HDMI video camera as the input.
2. Connect a program audio source to the MediaPort Line input as needed. Figure 77
above shows an iPod as the program audio input.
3. Connect a microphone to the MediaPort Mic/Line input.
4. Connect the MediaPort analog Line output to a sound reinforcement system.
5. Connect a USB cable between the MediaPort rear panel USB type B connector
and a USB type A connector on the PC or Mac computer. Make sure the drivers are
configured properly.
6. Configure the MediaPort 200 as a speakerphone device in Windows (see Configuring
Windows for MediaPort 200 on page 27).
7. Set proper gain structure. Follow instructions provided in Gain Structure on the next
page.
figure 77.
Application 1– Standalone MediaPort 200 for Soft Codec
Conferencing
MediaPort 200 • Standalone Application Setup 86