6. Charging System
Charging circuit
Current Leakage Inspection
Turn the main switch to OFF position, and
remove the negative cable terminal (-) from the
battery.
Connect an ammeter between the negative
cable terminal and the battery negative
terminal.
Caution
In the current leakage test, set the current
range at the largest scale, then gradually
decrease to the lower scale as the test process
goes to avoid possible damage to the ammeter
and the fuse.
Do not turn the main switch to ON position
during test.
If the leaked current exceeds the specified
value, it may indicate a short circuit.
Allowable current leakage: Less than 1mA
Disconnect each cable one by one and take
measurement of the current of each cable to
locate the short circuit.
Summary of Contents for Patriot 430
