2. Unpacking and Placement
Unpacking
The EVS Synapse card must be unpacked in an anti-static environment. Care must be taken NOT to
touch components on the card – always handle the card carefully by the edges. The card must be stored
and shipped in anti-static packaging. Ensuring that these precautions are followed will prevent
premature failure of components mounted on the board.
Placing the Card
The Synapse card can be placed vertically in an SFR18 frame or horizontally in an SFR04 and SFR08
frame. Locate the two guide slots to be used, slide in the mounted circuit board, and push it firmly to
locate the connectors.
Correct insertion of the card is essential, as a card that is not located properly may show valid indicators,
but will not function correctly.
On power up, all LEDs will light up for a few seconds. This is the time it takes to initialize the
card.
Power Consumption
When using MGG or MGU cards, the power consumption is higher than usual because of the high-
performance chips on the board. The following power supply and card combinations are recommended.
Power Supply
Power level (W) Number of Cards
SMP25
75
2
SMP80
240
6
SMP110
330
8
SMP175
525
8 cards (12 cards when using an SFR18 Gen3 frame)
2
| December 2021 | Issue 1.00.B
