3. Quick Start
Powering Up
On powering up the Synapse frame, the card set will use basic data and default initialization settings. All
LEDs will light up during this process. After initialization, several LEDs will remain lit – the exact number
and configuration is dependent upon the number of inputs connected and the status of the inputs.
Default Settings
In its default state, the MGG100 will act as dual-head, eightfold split. The auto format detection will
recognize the input format. The SDI outputs are set to four-wire 4K resolution with a frame rate of 60 Hz.
3.1.
Changing Settings and Parameters
The front panel controls or Cortex can be used to change the settings. An overview of the settings can
be found in later chapters of this manual. Please refer to "Graphical User Interface" on page 12 and
"Events Menu" on page 40.
Front Panel Control
Front Panel Display and Cursor
Settings are displayed and changed as follows:
Use the cursor ‘arrows’ on the front panel to select the menu and parameter to be displayed and/or
changed.
Move forward through the menu structure.
Go back through the menu structure.
Move up within a menu, or increase the value of a parameter.
Move down through a menu or decrease the value of a parameter.
INSTALLATION AND OPERATION MANUAL
Synapse MGU100 - MGG100 | 3. Quick Start |
3
