Evoqua WALLACE & TIERNAN DEPOLOX 400 M, Operating Manual, Page: 66 / 152

66
WT.050.700.000.DE.IM.0319
Installation
DEPOLOX
®
400 M
5.
5.4.12 Fitting calibration aids
The flow cell modules DEPOLOX
®
5 C and VariaSens C have two cali
-
bration clips in the housing cover. They are pushed into the side of the
basic housing at the back.
The clip with the plastic insert for the sensor is pushed into the top catch
(A).
The second clip is for holding calibration solution in a bag or beaker. For
solution in a bag, fit the clip in the top position of the bottom catch (B). For
solution in a beaker, select the position below this (C).
Image 12Rear side of the flow cell module DEPOLOX
®
5 C, pressurized
version
A Top holding clip
B Position of holding clip for bag
C Position of holding clip for beaker
5.4.13 Installing a sensor in the Y-style flow-through assembly
Proceed as follows to install the pH or fluoride sensor in the Y-style flow-
through assembly:
1 Fit the pH or fluoride sensor into the sensor holder.
2 Tighten the clamping nut to hold the electrode shaft.
Image 13Section, Y-style flow-through assembly
A Sensor holder
A
B
C
A