Section 3
Page 3 - 18
MODEL 346 INSTALLATION AND OPERATION MANUAL
HA243820
Issue 5 Mar 98
3.3.3 OPERATOR MENU (Cont.)
TOTALISER RESET
Rset Total.?
N
The up/down arrow keys are used to select the totaliser which is to be reset. Refer to the section 5 (Options)
for further details. Once the required totaliser number has been selected by operation of the ENTER key, a
further operation of the ENTER key is required to initiate the reset.
Rset Total.?
ENTER to confirm
Notes..
1. The resetting of a totaliser causes an internal trigger, which may have been configured to affect other re-
corder functions.
2. The totaliser must have been configured as ‘Resettable’ in the totaliser configuration.
PRIMARY CHART SPEED
Pri. Chart Spd
_XXXX MM/HR
The up/down/side arrow keys are used to set the primary chart speed. The speed units (‘in/hr’ or ‘mm/hr’) are
defined in the instrument configuration menu (section 4.9) and are not configurable from the above display.
CHART ADVANCE
Chart Advance
Off
The up/down arrow keys are used to operate the chart advance. When selected ON, the chart will advance at
maximum speed, until selected OFF again.
CHART HOLD
Chart Hold ?
Off
The up/down arrow keys are used to operate Chart Hold function.
With hold selected ON, chart motion and annotator printing are inhibited. The tracing of measured values will
however continue, and if chart hold is active for extended periods with rapidly changing input signals, damage
may be caused to the chart.
PEN PARK
Pen Park
Off
The up/down arrow keys are used to stop the chart and to position the pens for replacement. See section 3.2.5
for replacement instructions.
