HA243821
Issue 5 Mar 98
Section 3
Page 3 - 9
MODEL 346 INSTALLATION AND OPERATION MANUAL
3.2.3 Z-FOLD CHART REPLACEMENT (Cont.)
LOADING THE CHART
Orient the chart such that the end with the red stripe is at
the bottom of the pack.
Lift the top leaf of the chart and if necessary turn the
chart to ensure a) that the calibrated face of the chart will
be facing out when the chart is loaded, and b) that the
slots in the chart are at the right-hand side of the cas-
sette as viewed from the front of the cassette as in-
stalled in the recorder.
Insert the chart into the cassette, and pull approximately
30 cm (1 ft.) of chart between the open paper guide and
the roller, as shown in figure 3.2.3d
Fold the free end of the chart, so that it folds naturally,
and place the folded end into the take-up tray as shown
in figure 3.2.3e
IF THE DIRECTION OF FOLDING IS REVERSED, THE
CHART WILL NOT TRANSPORT CORRECTLY, AND
WILL FAIL IN OPERATION.
Ensuring that the chart is square with the cassette sides,
and that the chart holes are correctly located on the
sprockets, carefully push the metal cover assembly to its
closed position, and latch it by closing the paper guide
moulding over it (figure 3.2.3f) Ensure that it clicks into
position.
Close the door moulding, ensuring that it also clicks into
position. This sequence is shown in the diagram at the
right- -hand end of the cassette
Figure 3.2.3d Chart loading (1)
Figure 3.2.3e Chart loading (2)
Figure 3.2.3f Chart loading (3)
