10.5
Changing the heating power set
During normal operation of the stove (Work) you can change the heat power output by using the
buttons P5 (Decrease) and P6 (Increase). The power level set is shown on the display. (
Figure 7
) To exit
from the set wait 5 seconds
without performing any
operation on the keyboard,
or press P3.
Figure 7
10.6 Changing the room temperature
To change the room temperature it is sufficient to act on the button P1. The display shows the set
room temperature (SET temperature). Thus acting on the buttons P1 (increase) and P2 (decrease) it is
possible to change the value. After about 5 seconds the value is stored and the display returns to the
normal mode, or press P3 to exit. (
Figure 8
).
Figure 8
10.7 The room temperature reaches the set temperature
(SET temperature)
When the room temperature has reached the set value, the heating power of the stove is
automatically decreased to the minimum. Under these conditions, the display shows the message
"
MODULAT-
". (
Figure 9
). If the room temperature falls below the set one (Set temperature) the stove
goes back to "Work" mode and the power previously set (Set power).
Figure 9
03
set
power
30.0°
c
Set room
temp
14:15
22.5°
c
P-2
work
Modulat-
