Connector Type
Connection 1
Connection 2
Label in
Figure
CAT 5E Ethernet Cable PXI Controller,
10/100/1000 LAN Port
Network Switch
7
CAT 5E Ethernet Cable Network Switch
Ettus USRP X410 ETHERNET
Port
7
Power Supply
―
Ettus USRP X410 POWER Port 8
Table 7. Ettus USRP X410 Connections (NI-USRP)
Note
If you choose not to use the optional network switch, use one CAT 5E
Ethernet cable to connect the Ettus USRP X410 to the PXI Controller. This
hardware setup requires additional configuration in software. Either set a
DHCP server on the PXI controller or set a static IP address on the Ettus
USRP X410.
Powering on the Device
1. Connect the power supply to the Ettus USRP X410.
2. Plug the power supply into a wall outlet. Press the power button on the front
of your device.
3. Power on the chassis and network switch.
Installing the Software
You must be an Administrator to install NI software on your computer.
1. Install your ADE, LabVIEW.
2. Download the driver software installer from
NI Package Manager downloads with the driver software to handle the
installation. Refer to the NI Package Manager Manual for more information
about installing, removing, and upgrading NI software using NI Package
Manager.
3. Follow the instructions in the installation prompts.
ni.com
14
Ettus USRP X410 Getting Started Guide
