Figure 4. Module Installation
2
1
3
1. Chassis
2. Hardware module
3. Ejector handle in downward (unlatched position)
9. Latch the module in place by pulling up on the ejector handle.
10. Secure the module front panel to the chassis using the front-panel mounting
screws.
Note
Tightening the top and bottom mounting screws increases
mechanical stability and also electrically connects the front
panel to the chassis, which can improve the signal quality and
electromagnetic performance.
11. Complete steps 5 through 10 for the PXI controller and PXI bus extension
module.
12. Cover all empty slots using either filler panels (standard or EMC) or slot
blockers with filler panels, depending on your application.
Note
For more information about installing slot blockers and filler
panels, go to
.
Connecting the Device (NI-USRP)
The following describes one hardware configuration option. Other configurations
are possible.
Connect your hardware as shown in the following diagram.
ni.com
12
Ettus USRP X410 Getting Started Guide
