23
The camera will perform a test scan movement during startup. If the camera
doesn’t move or there is no power, then likely the camera module cabling needs
to be verified. Unplug the power before disassembling and verifying cabling.
Slide the camera into the hole in the ceiling. Make sure the clips are set back far
enough from the outer housing lip and ceiling to catch the ceiling and prevent
the camera from falling through the hole.
Screw the dome cover into the inner housing.
Connect the power cable to the combo cable power connector.
Summary of Contents for EV6250A Series
