15
Run the combo cable through the power box cable conduit.
Using the two screws provided, screw shut bracket arm/power box housing.
Connect the power cable to the combo cable power connector.
The camera will perform a test scan movement during startup. If the camera
doesn’t move or there is no power, then likely the camera module cabling needs
to be verified. Unplug the power before disassembling and verifying cabling.
Summary of Contents for EV6250A Series
