[email protected] phone +39 0444 419762
www.esmach.com
p.
87
English
3.3.2
MACHINE START-UP
After connecting the machine to the power supply socket, switch on (ON) the main power switch (18)
3.3.3
“MANUAL” OPERATING MODE
E Version
( ELECTRONICAL COMMANDS; see picture below )
To operate in
MANUAL
mode the led (12) has to be off and the display (8) has to show “H”; if the led (12) is
on, press the button (1) once.
To start the machine in 1
st
speed , press the button (15); the display (2) starts to count and shows the 1
st
speed working time run.
To let the machine operate in 2
nd
speed, press again the button (15); the display (5) starts to count and
shows the 2
nd
speed working time run; if the display(5) is blinking, this means that the 1
st
speed minimum
working time ( 2 minutes or 2 seconds depending on the bowl cover, i.e. grid or full cover) has not yet
elapsed.
To return to 1
st
speed operating, it is sufficient to press again the button (15).
To stop the machine on normal conditions, press the button (16); in this case the timers remain stopped at
the time shown after stopping; if the button (15) is pressed again, they re-start to count from the point it had
been interrupted.
To set both timers to zero, press the button (16) twice; the displays (2) and (5) shall indicate “000” and “000”.