KK-EPA.004 Rev No:0 28.09.18
14
6.4.2 Delay
The relay specifies in seconds how long it will active and inactive after it is switched off. If '0' is entered as a
zero value in the Stand function, the relay will remain
drawn
unless the relay output condition changes.
6.4.3. Hysteresis
Due to the unstability in decimal value read on the connected sensor, you can enter the hysteresis value to
prevent the relay from being turned on and off at any time, so that the set value you set for the relay will
be activated and inactivated as low as Hysdn and above Hysup.
0
20
The new delay value you confirmed with the
PRG button has been set. You can return to
run mode with the ESC button.
Press and hold the PRG button.
delay
20
OUT - 1
OUT
delay
0
When you press and hold
to the PRG key , the value
in the second line starts
blinking. Enter the desired
value using the UP and
DOWN
OUT
0
30
30.
30
The decimal point starts
blinking. Use the UP and DOWN
buttons to select the decimal
digit point.
Press and hold the UP button to move to the
next step.To enter a negative (-) value, move
to one of the non-digit digits and press the
DOWN button.
When you press
and hold to the PRG
key , the value in
the second line
starts blinking.
Enter the desired
value using the UP
and DOWN
.
Press and hold the PRG button.
OUT - 1
Hysup/hysdn
0
hysup
30
The new hysteresis value you confirmed with the PRG button
has been set. You can return to run mode with the ESC button.
* You can also set other relay outputs in the same
way.
* You can also set other relay outputs in the same
way.
bağlantıları:
