KK-EPA.004 Rev No:0 28.09.18
11
6.2.4 Start Calibration (START)
After selecting the number of calibration, press the button to access the start menu.
Error Message:
6.3. ADJUSTING THE RELAY SET VALUES
Your device has tree relays in total with two contacts, normally open and normally closed. You can use the
relay contacts in five different functions according to your needs. These functions are described by 6.4.1
6.3.1. Relay Output Settings
Set the SET values in which the relay outputs of your device will be activated.
For SET 1 value;
This error message can only be seen on devices with 4-20mA and 0.5-4.5V inputs.
Meaning; The sensor is not connected to the device or the sensor is defective.
OUT
25
30
30.
0.30
The decimal point
starts blinking. Use the
UP and DOWN buttons
to select the decimal
digit point.
Press and hold the UP button to move to the next
step.To enter a negative (-) value, move to one of
the non-digit digits and press the DOWN button.
When you press and
hold to the PRG key ,
the value in the
second line starts
blinking. Enter the
desired value using
the UP and DOWN
buttons.
The new SET-1 value you confirmed with the PRG button has
been set. You can return to run mode with the ESC button.
* You can also set other relay outputs in the same way.
START
SEG. 1
XXX
. . .
This process is
repeated for
each segment.
.DONE.
Press and hold the PRG button.
SET - 1
0.30
OUT - 1
SET - 1
25
Sn. err
