KK-EPA.004 Rev No:0 28.09.18
16
6.4.6. Sensor Selection (Snsor)
Assignment can be done to the selected relay for the sensor types shown below.
Sensor Type:
6.5. ANALOGUE OUTPUT SETTINGS
If your EPA 200, which is specially manufactured according to your order, has analogue output module, you
can make the necessary settings on this menu.
6.5.1. Analogue Output Type Selection
Under the Type menu, any of the following analogue output types can be selected.
DEFAULT
When the relay output is wanted to be activated for sensor input, the
"DEFAULT" should be selected.
TEMP.
When the relay output is wanted to be activated for Thermocouple or RTD
input, the "TEMP" should be selected.
CAN.dt 1
When the relay output is wanted to be activated for CAN-Open
communucation connection through data-1, the "CAN.dt1" should be
selected.
CAN.dt 2
When the relay output is wanted to be activated for CAN_Open
communucation connection through data-2, the "CAN.dt2" should be
selected.
OUT
dfault
temp
When you press
and hold to the
PRG key , the value
in the second line
starts blinking.
Enter the desired
value using the UP
and DOWN
buttons. Sensor
types that can be
selected and
descriptions are
shown below.
Press and hold the PRG button.
OUT - 1
snsor
temp
The new sensor type you confirmed with the
PRG button has been set. You can return to
run mode with the ESC button.
snsor
dfault
* You can also set other relay outputs in the same
way.
bağlantıları:
OUT
0-10V
4-20ma
When you press and
hold to the PRG key ,
the value in the
second line starts
blinking. Enter the
desired value using
the UP and DOWN
buttons. Output
types that can be
selected are shown
below.
Press and hold the PRG button.
anlog
type
4-20ma
The new output type you confirmed with the PRG button has
been set. You can return to run mode with the ESC button.
type
0-10V