KK-EPA.004 Rev No:0 28.09.18
6
4. FRONT PANEL IDENTIFICATIONS
SAFETY WARNINGS
1.
Always follow the instructions and instructions in the operating instructions before making
the connections and during use.
2. Please check the power supply type before you connect energy to your device.
3.
During the operation, be sure to mount it firmly on the panel to be used against falling,
sliding, shaking and shaking.
4.
Make sure the sensor connections are not energized in your device, and do not disconnect or
connect the devices while the device is running.
5.
Make sure that the cables between the sensor and your device are shielded and free from
high-current energy cables.
6.
Do not expose your device directly to a heat source (solar, heater, etc.) in its operating
environment.
7.
The EPA200 is an industrial control device which is not suitable for outdoor use; please use
only in room conditions.
8. Wipe with a damp cloth to clean your device, do not use water, alcohol, thinner and
similiar chemicals.
9. Comply with the limit values specified in the technical specifications for relay outputs.
10. The device cannot be changed by the user in the event of a fault, Please contact our
technical service in case of failure.
1) Top Display Line:
It has 5 digits and shows the
measured process value.
2)
Bottom Display Line:
It has 6 digits and shows the relay
setpoint, the temperature measured by the thermocouple
or the ambient temperature.
3)
Min
Status LED:
It lights up when the lowest
(minimum) value has been read since the moment the
device is started.
4) Max Status LED:
It lights up when the maximum value
has been read
since the moment the device is started.
5) Tare Status LED:
It lights up when the Tare function is
active.
1
2
3
5
4
6
7
8
9
6) Set Status LEDs:
The LED associated with the active relay lights up.
7)
PRG Button:
Programming and Enter key. It is used to enter menus or to confirm entered values.
8) ESC Button:
Escape, exit and back key. It is used to return to the upper menu or to exit the menu.
9)
UP and DOWN Buttons:
Navigating through the menus; is used to increase and decrease the value while entering
values, or to move to a lower and higher digit.
