Ericsson SmartEdge 600, Hardware Manual

Page: 173 / 174

SmartEdge Storage Engine
•
reload card
—Shuts down the card for removal and reinsertion.
•
reload disk
—Shuts down the specified SSE disk and reloads the disk.
This command is equivalent to removing and reinserting the disk.
Note: If you issue this reload disk command on the active card during
data synchronization on any partition, a warning message appears.
•
show administrators
—Displays administrator sessions on a system.
•
show chassis
—Displays installed and configured cards and their status.
•
show chassis power
—Displays power allocation for the current
SmartEdge chassis configuration.
•
show configuration
—Displays current configuration of the SmartEdge
router or the contents of the previously saved configuration file on the local
file system.
•
show configuration sse
—Displays current configuration of all SSE
cards on the system.
•
show disk
—Displays disk info for the SSE card.
•
show disk sse counters
—Displays disk counters for the SSE card.
•
show hardware
—Displays information about the system hardware.
•
show sse group | partition
—Displays SSE group or SSE partition
counters.
•
show sse group | partition counter
s—Displays SSE group or
SSE partition information.
•
show system alarm
—Displays system-level alarms.
•
show version
—Displays current version of the software running on the
system.
•
sse group switch-over
—Performs a manual switchover on an SSE
group configured with redundancy to the standby SSE card or disk. The
standby SSE card or disk must be available.
•
telnet to SSE
—Accesses the SSE Linux shell via telnet from the
XCRP’s management interface for development and debugging purposes
only.
•
UNIX/DOS Commands
—Allows you to utilize the UNIX/DOS commands
supported on the CLI. For users with CLI admin privileges only.
For more information on SSE-related commands,
see related
documentation at https://ebusiness.ericsson.net.
167
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09