Ericsson SmartEdge 600, Hardware Manual

Page: 141 / 174

Card Descriptions
Because of the number of 10/100 ports on the 60-port Fast Ethernet card,
facility LEDs on those ports are organized differently. Each 10/100 port is
identified by two LEDs:
• A connector LED identifies which connector has been selected using the
push button (labeled CONN SELECT) at the bottom of the front panel.
• A port LED identifies the operating speed of the port and its status.
Table 114 Facility LEDs for 100/1000 Ports on 60-Port Fast Ethernet Card
Label Activity Color Description
On Green The link is present and active.
On Blinking The link is transmitting and receiving frames.
LNK ACT
Off None The link has no active frame.
On Yellow The link is operating at 100 Mbps.
On Green The link is operating at 1000 Mbps.
SPD
Off None The link is operating at 10 Mbps.
6.11 4-Port Gigabit Ethernet Card
The 4-port Gigabit Ethernet card is the first version of the Gigabit Ethernet card.
This 4-port GE card provides two out of four optical Ethernet ports and supports
256 MB for each Packet Processing ASIC (PPA) on the card.
This card is the same size as all other SmartEdge line cards and occupies
a single slot in the chassis. The following types of GBIC transceivers are
supported on any of the ports:
• 1000Base-SX—Short Reach
• 1000Base-LX—Long Reach
• 1000Base-LX70—Extended Reach
• 1000Base-TX—Copper
Either card can have any combination of the listed types of GBIC transceivers
installed.
Caution!
Risk of data loss. You can corrupt the system if you attempt to install
transceivers (GBICs, SFPs, or XFPs) that are not purchased from Ericsson
because these items have not been tested with the SmartEdge router. To
reduce the risk, install only the transceivers purchased from Ericsson.
135
27/153 30-CRA 119 1170/1 Uen A | 2010-04-09