ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
8. Compound cut
A compound cut is the combination of a mitre
and a bevel cut simultaneously.
1) Loosen the bevel lock handle (1) and position
the cutting head at the desired bevel position.
Lock the bevel lock handle.
2) Loosen the mitre handle (2). Press down the
positive stop locking lever (3) and position the
table at the desired angle. Release the positive
stop locking lever and lock the mitre handle.
x
9. Slide cutting wide boards up to 300mm wide
Warning:
To avoid injury:
]
spinning blade toward you during the cut. The
blade may try to climb up on the top of the
workpiece, causing the cutting assembly and
spinning blade to kick back, forcefully. The
cutting head assembly should be drawn back
completely then pushed forward when sawing.
This will help reduce the risk of a thrown
workpiece.
To slide cut wide boards
1) Unlock the carriage lock handle (1) and allow
the cutting head assembly to move freely.
2) Set both the desired bevel angle and/or the
mitre angle and lock into position.
3) Use a hold down clamp to secure the
workpiece.
4) Grasp the switch handle (2) and pull the
carriage (3) forward until the centre of the saw
blade is over the front of the workpiece (4).
5) Engage the trigger to turn the saw on.
6) When the saw reaches full speed, push the
switch handle down, slowly, cutting through the
leading edge of the workpiece.
7) Slowly move the switch handle toward the
fence, completing the cut.
@
stop spinning before allowing the cutting head
xx
Fig 32
1
2
3
Fig 33
1
3
4
2
