ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
D0DLQWDLQDÀUPJULSZLWKERWKKDQGVRQWKHVDZDQGSRVLWLRQ\RXUDUPVWRUHVLVW
kickback forces. Position your body to either side of the blade, but not in line with
the blade.
?## $ # ###
be controlled by the operator, if proper precautions are taken.
b. When blade is binding, or when interrupting a cut for any reason, release the
trigger and hold the saw motionless in the material until the blade comes to a
complete stop. Never attempt to remove the saw from the work or pull the saw
backward while the blade is in motion or kickback may occur.
Investigate and take
corrective actions to eliminate the cause of blade binding.
c. When restarting a saw in the workpiece, centre the saw blade in the kerf and
check that saw teeth are not engaged into the material.
If saw blade is binding, it
may walk up or kickback from the workpiece as the saw is restarted.
d. Support large panels to minimise the risk of blade pinching and kickback.
Large
panels tend to sag under their own weight. Supports must be placed under the panel
on both sides, near the line of cut and near the edge of the panel.
e. Do not use dull or damaged blades.
Unsharpened or improperly set blades
# ! ###
f. Blade depth and bevel adjusting locking levers must be tight and secure before
making cut.
$
kickback.
