ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
ASSEMBLY INSTRUCTIONS
Warning:
$
this mitre saw to the power source until
$
have read and understood this Operator’s Manual.
1. Installing the mitre handle
1) Thread the mitre handle (1) into the hole
x
2. Unlocking the slide carriage
After removing the saw from the carton,
loosen the slide carriage lock knob (1). When
transporting or storing the mitre saw, the slide
carriage should always be locked in position.
The slide carriage lock knob (1) is located on the
3. Raising the Cutting Head
1) Push down slightly on the switch handle (1)
and the lock lever (2).
2) Pull out the stop latch knob (3).
3) Allow the cutting head to rise to the up
V
Warning:
$
to the saw, transport and store the
mitre saw with the cutting head locked in the
down position. Never use the stop latch to hold
the cutting head in a down position for cutting
operations.
Locking
When transporting or storing the mitre saw, the
cutting head should always be locked in the down
position.
1) Push the lock lever (2) and cutting head down
to its lowest position.
2) Push the stop latch knob (3) into the locking
hole.
IMPORTANT
To avoid damage, never carry the mitre saw by
the cutting arm or the mitre handle. ALWAYS use
both designated carrying handles together.
Fig 5
1
2
3
Fig 4
1
Fig 3
1
