ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
MAINTENANCE
Danger:
$
lubricants on the blade while it
is spinning.
Warning:
!
reaction, never use petrol, naphtha,
volatile solvents to clean the mitre saw.
Warning:
For your safety, this saw
is double-insulated. To avoid
# $
@ !
to avoid electrical shock.
Replacing carbon brushes
Replace both carbon brushes when either has
less than 6 mm length of carbon remaining,
or if the spring or wire is damaged or burned.
the saw. Then remove the black plastic cap
(1) on the side of the motor (2). Remove the
cap cautiously, because it is spring loaded.
Then pull out the brush and replace. Replace
for the other side. To reassemble reverse the
procedure. The ears on the metal end of the
assembly go in the same hole the carbon part
x
Note:
make sure the brushes go back in the way
they came out. This will avoid serviceable
brushes undergoing a second ‘bedding
in’ process that could reduce motor
performance and increases wear.
Lower blade guard
Do not use the saw without the lower blade
guard. The lower blade guard is attached to the
saw for your protection. Should the lower guard
become damaged, do not use the saw until the
damaged guard has been replaced. Develop a
regular check to make sure the lower guard is
working properly. Clean the lower guard of any
dust or buildup with a damp cloth.
Fig 43
1
2
