ERBAUER 254MM (10”) SINGLE BEVEL SLIDING MITRE SAW
3. Bevel pointer adjustment
P 0 ! [
°
[
°
) to the
table, loosen the bevel indicator screw (1) using
a # 2 Phillips screwdriver.
\$
:[
°
” mark on
the bevel scale and retighten the screw.
(See
[
4. Bevel adjustment 45°
1) Loosen the bevel lock handle (1) and tilt the
cutting head completely to the left.
#
the blade angle is 45
°
to the table.
3) If the blade is not at 45
°
to the mitre table,
tilt the cutting arm to the right, loosen the
#
$
x
# $
(3) depth in or out to increase or decrease the
bevel angle.
4) Tilt the cutting arm to the left to 45
°
bevel
and recheck for alignment.
5) Repeat steps 1 through 4 until the blade is at
V
6) Tighten bevel lock handle (1) and locknut (2)
when alignment is achieved
.
P
5. Bevel Setting for Crown Moulding
xx
°
for
cutting crown mouldings.
1) Twist and deploy sprung-loaded crown
moulding pin (2).
2) Loosen the bevel lock handle
(1)
and rotate
!
#
/ [
Fig 21
Fig 22
1
2
1
2
3
2
3
1
2
3
4
3
