Supported Media
The following media can be used with the printer.
Print quality is greatly affected by the type and quality
of media used. Choose a media suited to the task at
hand. For information on use, refer to the
documentation supplied with the media or contact the
manufacturer. Before buying media in large quantities,
try printing on a smaller sample and check the results.
c
Important:
Do not use media that is wrinkled, scuffed, torn,
or dirty.
Roll media
Roll core size
2 or 3 inch
Roll outer
diameter
150 mm (5.9 in.) or less
Media Width
*
254 mm (10 inches) to 1118 mm (44
inches)
Media
thickness
0.08 to 0.5 mm (0.003 to 0.02 in.)
* 432 mm (17 inches) to 1118 mm (44 inches) when the auto
take-up reel unit is installed.
Moving and Transporting
the Printer
This section describes how to move and transport the
product.
Moving the Printer
This section assumes that the product is being moved
to another location on the same floor without
traversing stairs, ramps, or lifts. See below for
information on moving the printer between floors, to
another building, or between non-level floors.
U
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to
observe this precaution could result in the printer
falling over, causing accidents.
Getting Ready
Make the following preparations in advance before
moving the printer.
❏
Turn off the printer and remove all cables.
❏
If the printer has a waste ink bottle, install a new
waste ink bottle to prevent ink from dripping.
❏
Remove the media.
❏
Remove any optional components if they are
installed.
❏
Unlock the stand.
Post-Move Setup
After moving, make the following settings to get ready
for printing.
❏
Check that the location is appropriate for
installation, and set up the printer.
North American and Latin American users:
Contact your dealer for product installation
information. Damage to the product from
unauthorized installation will not be covered by
your Epson warranty.
Other regions:
U
Setup Guide
(booklet)
❏
Plug in the power cables and turn the printer on.
North American and Latin American users:
Contact your dealer for product installation
information. Damage to the product from
unauthorized installation will not be covered by
your Epson warranty.
Other regions:
U
Setup Guide
(booklet)
❏
Perform a nozzle check to check for clogged
nozzles.
U
“Print Head Nozzle Check” on page 64
❏
Perform Print Head Alignment and check the
print quality.
U
“Print Head Alignment” on page 44
SC-F6400 Series/SC-F6400H Series User's Guide
Appendix
98
