Epson SC-F2000 Series, Service Manual

Page: 24 / 312

SC-F2000 Revision C
PRODUCT DESCRIPTION Operation panel specifications 24
Confidential
Maintenance
Replace White Ink
Yes If [Yes] is selected, mode can be switched from the current mode to other modes (High Speed
Color Mode is not available).

Using in White Ink Mode: switch to Color Ink Mode

Using in Color Ink Mode: switch to White Ink Mode
If White Ink Mode will not be used for more than 2 weeks, switch to Color Ink Mode to prevent
from quality deterioration of printing.
No
Prolonged Storage
Yes If this printer will not be used for more than a month, exchange ink with cleaning fluid to prevent
the quality deterioration. Prepare a cleaning cartridges and waste ink bottle before exchanging.
If the White Ink Mode will not be used for more than 2 weeks, use Replace White Ink instead of
this setting.
No
Printer Setup
Head Alignment -
When the printed copy occurs granularity or out of focus, execute Head Alignment. Adjust the
misalignment of print head when printing by each size of Platen. Check the printed check pattern
visually. Calibrate by entering the Adjusting level that does not show fine lines. If there is no
optimum Adjusting level to the printed check pattern, enter “1” or “13” before executing this
setting again. When [Uni-Directional] is chosen by software or by configuration of this printer, it
does not effect on the printed copy.
Offset Head Alignment
-10 to +10 (default
values "1")
Used for printing on T-shirts when printing sides are uneven (such as pockets) and can not adjust
Platen. Height adjustment lever lowers the level of Platen. In this state, Adjusting level should be
around “+3”. Execute Head Alignment again not for the image to stir. This setting returns to
default level if undoing Head Alignment after having Offset Head Alignment done.
Feed Adjustment
-1.00 to +1.00% (default
values "0.00") Adjusts the width (amount of sent Platen when print head moves one time). If fine deep-colored
lines are found, adjust towards "+". If fine light-colored lines are found, adjust towards "-".
Power On Cleaning* White Ink
On Chosen only in White Ink Mode. The quality of printing may drop if cleaning has not been done
for a certain period for white ink. Sedimentation of ink component or nozzle clogging may be the
cause. ON: Executes cleaning after the power has been activated and initial movement is over.
Before printing: Executes cleaning when the power has been activated and before it starts
printing for the first time. Period of cleaning may differ according to how long the power had
been off. It may take for up to approximately 20 minutes.
Before Printing
Off
Print Logs
Print Job Log Sheet Print Press [OK] to print history of printing.
Total Prints xxxxxx pages Displays total of printing copies (up to 6 digits).
Printer Status
Level
Ink Displays each remaining ink. Exchange of ink cartridge will reset remaining ink automatically.
Head Cleaning Set Displays the remaining amount of head cleaning set.
Firmware Version xxxxxxx,x.xx,xxxx Displays firmware version of this printer.
Print Status Sheet Print
Prints the list of set up state of this printer.
Each information can be checked collectively.
Table 1-15. Setup menu
Menu Set up Item/level (shaded area: default setting) Description