Safety Instructions
3
❏
Never disassemble, modify, or attempt to repair
the AC adapter, power cord, printer, and options
by yourself except as specifically explained in the
printer's guides.
❏
Unplug the printer and the AC adapter, remove
the optional battery from the printer, and refer
servicing to qualified service personnel under the
following conditions:
The power cord or plug is damaged; liquid has
entered the printer, the AC adapter, or the
optional battery; the printer, the AC adapter or
the optional battery has been dropped or the
casing damaged; the printer, the AC adapter or
the optional battery does not operate normally or
exhibits a distinct change in performance. (Do not
adjust controls that are not covered by the
operating instructions.)
❏
Do not use with wet hands.
❏
If you plan to use the AC adapter in Germany, the
building installation must be protected by a10 or
16 amp circuit breaker to provide adequate
short-circuit protection and over-current
protection for this printer.
For United Kingdom, Singapore, and Hong Kong
users
❏
Replace fuses only with fuses of the correct size
and rating.
Safety requirements
Mains plug:
Use a 3-pin mains plug that is registered with the
Safety Authority.
Flexible cord:
Use a double insulated flexible cord that is certified*
to the relevant IEC or BS standards.
Appliance connector:
Use an appliance connector certified* to the relevant
IEC or BS Standards.
* certified by member of IECEE CB Scheme.
For United Kingdom users
The following safety information applies to the AC
adapter.
❏
Warning:
Refer to the rating plate for the voltage
and check that the appliance voltage corresponds
to the supply voltage.
Summary of Contents for PictureMate 100
Page 6: ...vi ...
