Epson LQ-570e, Service Manual

Page: 97 / 129

EPSON
LQ-570e/LQ-580
Revision
C
Adjustment Adjustment
and Resetting the Printer
97
5.2.3
Factory Setting
The
factory settings of the printer for each destination are installed in the EEPROM on the
main
board. Therefore, If you have replaced the main board, you must re-install them again
by
the adjustment program. This section describes how to install the factory settings:
1. Connect
the printer and the host DOS/V computer with a parallel interface cable.
2. Set
the 10 inch width continuous paper to the printer.
3. Run
the adjustment program in the host computer.
Program Name: Q80A10V
* Run “Autoexec.bat” file from attached 3.5 inch program FD.
4. Operating
System selet menu appears. Type “G” to run GWbasic.
5. Printer
Name inputting menu appears. Input “LQ-570e or LQ-580”.
6. The
printhead wire select menu appears. Move the cursor using “ ↑
”
or “ ↓
”
key to
select
“24 pin” from the list and press “Enter” key.
7. Then
the market setting menu appears. Referring to the market list table, move the
cursor
using “
↑
”
or “
↓
”
key to select your market from the list and press “Enter” key.
To
change the choice to the other market after selection, you may press “ESC” key
only.
The market setting menu appears again. An example (for EUR) is shown below:
Table
5-3. Market List
Destination Code Destination Code
EAL,
ESP, EHK,
EHK(PHIL)
USASTD EDG
(NLSP), EUL (NLSP),
EIS
(NLSP)
NLSP
EURO,
EDG, EUL,
EUL
(230V, 240V), EFS,
EIS,
EIB
EURSTD EUL
(120V)
DEFSTD
EAI,
EAI (Latin)
USASTD2 EKL KOREAN
EMO RUSSIAN