Epson LQ-570e, Service Manual, Page: 31 / 129

EPSON
LQ-570e/LQ-580
Revision
C
Product
Description
Operation 31
1.5
Operation
1.5.1
Control Panel
6
switches and 8 LEDs are on the panel as shown below.
Figure
1-8. Control Panel
1.5.1.1
Switches
o
Operation
in normal mode
In
normal mode, pressing panel switches executes following function;
D r a f t
R o m a n
S a n s s e r i f
F o n t
R e s e t
T e a r O f f / B i n
T e a r O f f
B i n 1
B i n 2
C a r d
P a u s e
M i c r o A d j u s t
3 s e c .
P a p e r O u t
L F / F F L o a d / E j e c t
: L E D O n , : L E D B l i n k s , : L E D O f f
C o u r i e r
P r e s t i g e
S c r i p t
O t h e r s
C o n d e n s e d
Table
1-28. Operation in Normal Mode
Switch Function
Pause
-Alternates
printing and non-printing status.
-Enables
Micro Adjustment function, holding it down for 3 seconds.
-If
pressed again in the above condition, Micro Adjustment function
is
disabled.
Load/Eject
Micro
Adjust
↑
-When
no cut sheet/ CSF, load paper from CSF.
-When
there is cut sheet/ CSF, eject paper.
-When
no continuous paper, load continuous paper.
-When
there is continuous paper, eject continuous paper to the
tractor
waiting position.
-When
Micro Adjust is enabled, execute micro feed backward.
(0.14mm
(1/180 inch)) *1: See Figure 1-9, "Micro Feed".
-After
paper feed; at TOF position, TOP adjustment is executed; at
TEAR
OFF position, TEAR OFF position adjustment is executed; at
other
positions, micro feed is executed.
LF/FF
Micro
Adjust
↓
-When
no cut sheet/ CSF, load paper from CSF.
-When
there is cut sheet/ CSF; if pressed short, start a new line; if
pressed
for seconds, eject paper; if roll paper, start a new line.
-When
no continuous paper, load continuous paper.
-When
there is continuous paper; if pressed short, start a new line; if
pressed
for seconds, start a new page.
-When
Micro Adjust is enabled, execute micro feed forward.
(0.14mm
(1/180 inch)) *2: See Figure 1-9, "Micro Feed".
-After
paper feed; at TOF position, TOP adjustment is executed; at
TEAR
OFF position, TEAR OFF position adjustment is executed; at
other
positions, micro feed is executed.
Tear
Off/ Bin
-If
cut sheet is selected, select CSF bin. (Including CARD)
-If
continuous paper is not at TEAR OFF position, carry continuous
paper
to the next page Tear-off position.
-If
continuous paper is at TEAR OFF position, carry continuous
paper
to the next page TOF position.
-If
no continuous paper, TEAR OFF SW is invalid.