Epilog Laser Fusion Pro 32, Original Instructions Manual

Page: 234 / 242

Machine Settings:
• Acceleration Match Offset [cnts]
● Number of encoder counts to delay firing laser when accelerating. Used for raster quality
adjustments
• Deceleration Match Offset [cnts]
●
Number of encoder counts to delay firing laser when decelerating. Used for raster quality
adjustments
• Bed Margins [in]
●
The margins around the bed, in inches that the carriage can travel to.
●
Format is as follows: TOP,LEFT,BOTTOM,RIGHT
• Bed Size [in]
●
The size of the bed in the machine in inches
●
Format is as follows: WIDTH,HEIGHT
●
Requires “Home Axis” to take effect
• Disable Table Homing
● Setting to disable homing the table when the machine boots. For optimal operation, leave this at
a value of 0
● A value of 1 will disable table homing
● Will take effect after reboot
• Rotary Encoder [cnts/in]
●
The number of encoder counts per inch of travel for the rotary device
●
Requires “Home Axis” to take effect
• X Axis Encoder [cnts/in]
●
The number of encoder counter per inch of travel for the X Axis
●
Requires “Home Axis” to take effect
●
Must recalibrate cameras if this changes
• Y Axis Encoder [cnts/in]
●
The number of encoder counter per inch of travel for the Y Axis
●
Requires “Home Axis” to take effect
●
Must recalibrate cameras if this changes
• Home Offset [in]
● The offset of the table origin, relative to the X and Y limit switches
● Requires “Park Axis” to take effect
● Must recalibrate cameras if this changes
• Joystick Center X
●
The center X position of the joystick, in joystick units
• Joystick Center Y
●
The center Y position of the joystick, in joystick units
• Joystick Deadzone [%/100]
●
The percentage of dead zone around the center of the joystick
• Joystick Limit X
● The MIN and MAX limits for the X axis of the joystick, in joystick units
- 228 -
APPENDIX C: SYSTEM CALIBRATION