EP Equipment CQD16, Service Manual

Page: 57 / 251

43
REV. 07/2016
DRIVE SYSTEM
5
5.2 Electromagnetic Brakes 5.2.1 Removal and Installation
Removal
The truck is braked through electromagnetic
brake. When the truck is powered off, the
electromagnetic coil (6) doesn't absorb the
pressure plate (8), the friction force generated
between brake pads (2), pressure plate and
friction plates (5) will prevent the drive motor
from rotating, thus to brake the vehicle.
No. Name
1 Mounting screws
2 Brake pads
3 Brake gear
4 Dust cover
5 Friction plate
6 Electromagnetic coil
7 Spring
8 Pressure plate
The brake is installed on the drive motor. See
Figure 90204
-
-
-
-
Switch off the truck power connections and
pull out the brake connectors;
Remove the three mounting screws (1) with
wrench. Remove the electromagnetic coil (2)
and dust cover (3);
Remove the brake pads (4) and friction plates
(5) by order;
Remove the circlip (6) on the shaft with circlip
pliers and remove the brake gear (7).