EP Equipment CQD16, Service Manual

Page: 215 / 251

201
REV. 07/2016
SERVICE MANUAL - MAST
A
- Block the truck wheels with wooden wedges,
raise the inner mast (8, Figure 90622) for
500mm, insert wooden block between inner
mast and the ground for supporting;
A3-2.2 Chain Replacement
Please place supporting under the inner mast
to prevent it from falling, resulting in personal
injury.
CAUTION
-
-
-
-
-
-
-
Remove the cotter pin (7, Figure 90603) and
unscrew the lock nut (2) and adjusting nut (9)
from the chain joint (1) and chain joint (6);
Remove the chain assembly from the chain
sprocket (5,Figure 90621);
Remove the cotter pin (3, Figure 90603)
and
fl at washer (8), pull out the pin shaft (4),
separate the chains (5) from the chain joint (1)
and chain joint (6);
Replace with new chains and hang the new
chain assembly onto the chain sprocket;
Put the chain connector (6) through the inner
mast chain-hanging plate, screw the adjusting
nut (9) and lock nut (2);
Put the chain connector (1) through the outer
mast chain-hanging plate, screw the adjusting
nut (9) and lock nut (2);
Adjust the chains according to Section A3-
2.1.
A3-2.2.1 Mast Chains - Block the truck wheels with wooden wedges,
raise the fork carriage for 500mm, insert
wooden block between inner mast and the
ground for supporting;
Please place supporting under the inner mast
to prevent it from falling, resulting in personal
injury.
CAUTION
-
-
-
-
-
-
-
Remove the cotter pin (7, Figure 90603) and
unscrew the lock nut (2) and adjusting nut (9)
from the chain joint (1) and chain joint (6);
Remove the chains from the chain sprocket
(10, Figure 90622);
Remove the cotter pin (3, Figure 90603)
and
fl at washer (8), pull out the pin shaft (4),
separate the chains (5) from the chain joint (1)
and chain joint (6);
Replace with new chains and hang the new
chain assembly onto the chain sprocket;
Put the chain connector (6) through the fork
carriage chain-hanging plate, screw the
adjusting nut (9) and lock nut (2);
Put the chain connector (1) through the
middle cylinder chain-hanging plate, screw
the adjusting nut (9) and lock nut (2);
Adjust the chains according to Section A3-
2.1.
A3-2.2.2 Fork Carriage Chains