EmoTouch 3 - Operating Instructions
11
Identification
2.2 Intended use
In conjunction with a suitable sauna heater, the EmoTouch 3 control unit is
intended to be used only to heat sauna cabins. It is suitable for cabins used
in private and commercial settings.
The relay box and control panel are intended only for mounting on the
wall.
The control unit is not suitable for outdoor use.
It must be operated only inside buildings and may not be exposed to envi-
ronmental conditions such as extreme humidity and moisture or the possi-
ble formation of condensation or corrosive substances in the ambient air,
as well as other weather conditions. Similarly, excessive cold and extreme
exposure to sunlight must be prevented. Protect the unit accordingly if
there is an increased risk of mechanical damage.
EmoTouch 3 relay box
The relay box is used to operate sauna heaters in Finnish mode and in
humidity mode.
EmoTouch 3 control panel
The EmoTouch 3 control panel is suitable for the operation of sauna cabins
in private and commercial settings. It must be mounted on a wall.
Foreseeable misuse
The following are considered instances of foreseeable misuse:
The control and sensor cable plugs are plugged in incorrectly.
The unit is operated without knowledge of or compliance with the
safety instructions.
Operating, service and maintenance requirements are not observed.
The unit is operated after technical or other modifications are made to
the relay box.
The unit is operated by children or persons with reduced mental capac-
ity or by persons who have not been thoroughly instructed in its use.
The manufacturer is not liable for unauthorised modifications made to the
equipment and damages resulting from these modifications. The person
modifying the equipment alone shall bear the associated risk.
