EmoTouch 3 - Operating Instructions
101
Service settings
NOTICE
Damage to the unit due to improper dismantling
The display can become scratched. The circuit board can break.
Do not tilt the front panel when dismantling.
Apply a consistent amount of pressure to the removal tool or
screwdriver when using it.
Do not scratch the front panel with the tools.
6.2.1 Configuration backup
Once a configuration has been fully set up, a backup should be created and
saved on an external storage device, e.g. on a PC or hard drive. With this
data, the configuration can be restored quickly after a reset or reboot.
If you want to restore a configuration with a backup, the backup files must
be copied to the
CFG
folder on the memory card.
You must carry out the following steps to create and read a backup:
Dismantling the front panel
1
Switch the off switch on the relay box to 0.
2
Insert the removal tool in the slot at the base of the control panel be-
tween the front panel and the housing.
3
NOTICE Do not tilt the front panel to avoid damage to the display.
Press the removal tool against the wall until the front panel comes loose
from the bottom piece.
4
Remove the front panel with a consistent amount of force from the
housing.
5
Rotate the front panel to the side until the circuit board is easy to access.
A
Front panel
C
Bottom piece
B
Removal tools
D
Wall
