SOLARDRIVE
PLUS
PROGRAMMING
GUIDE
20
/
107
3. Press the following keys to quit the last page displayed:
•
ESC
without saving the value to EEPROM if
P269b
=
0:[No]
press
ESC
to confirm the parameter,
that will not be saved (the previous value will be restored at next power on);
•
ESC
without saving the value to EEPROM if
P269b
=
1:[No]
press
ESC
to restore the previous
value;
•
SAVE/ENTER
(new values are saved to Eeprom).
2.2.8.
RESET Key (Alarm and Control Board Reset)
The
RESET
key is used to reset the drive after an alarm trips and the cause responsible for the alarm has
been removed.
Press the
RESET
key for
more than 5 seconds to reset the control board
and
reinitiate it.
This
procedure may be useful when changes made to
Rxxx
parameters (which activate only after resetting the
equipment) must immediately come to effect, with no need to switch off the drive.
