PROGRAMMING
GUIDE
SOLARDRIVE
PLUS
21
/
107
2.2.9.
TX/RX Key (Download/Upload from/to the Keypad)
Use the keypad to perform the following functions:
1. UPLOAD (parameters stored in the drive are copied to the display/keypad);
2. DOWNLOAD (parameters stored in the keypad are copied to the drive).
Press the
TX/RX
key to go to the UPLOAD page; press the
TX/RX
key again to toggle between the UPLOAD
and DOWNLOAD pages.
WARNING
A Warning is displayed (one among W41 to W46) when trying to DOWNLOAD parameters
to a drive whose SW Version, IDP, PIN or current/voltage classes are different from those
of the drive previously used for parameter UPLOAD. In that case, download is not allowed.
NOTE
The DOWNLOAD function allows the parameters stored in the keypad to be copied to the drive.
However, parameters are not stored to the non-volatile memory of the drive.
To store the downloaded parameters to the non-volatile memory of the drive, go to the EEPROM
menu and execute a “Save Work” command once the download procedure is complete.
Otherwise, when power is lost, the parameters downloaded to the drive are lost.
The
TX/RX
key is disabled under the following conditions:
•
no password is entered in
P000
•
the OPERATOR mode is activated with the
MENU
Key (
P264b
= OPERATOR)
•
the drive is running.
In the example below, you can go to the UPLOAD page from any page (the upper LED starts flashing). If you
then press the
TX/RX
key, you can go to the UPLOAD and DOWNLOAD pages.
Any page
.
A N Y
P A G E
UPLOAD Page
P a r a m e
t
e r
U P L O A D
i n v e r t e r
k e y p a d :
p r e s s
S A V E / E N T E R
t o
c o n f i r m
DOWNLOAD Page
P a r a m .
D
O
W N L O A D
k e y p a d
i n v e r t e r :
p r e s s
S A V E / E N T E R
t o
c o n f i r m
Press
SAVE/ENTER
from the UPLOAD (/DOWNLOAD) page to confirm UPLOADING (/DOWNLOADING).
The relevant LED will come on (fixed light).
If the
SAVE/ENTER
key is not pressed for confirmation within 10 seconds from the selection of the UPLOAD
(/DOWNLOAD) page, the starting page is automatically displayed.
While UPLOADING,
W08 UPLOADING (
flashing warning) appears.
If parameters are successfully uploaded, the following warning appears:
TX/R
X
TX/R
X
TX/R
X
TX/R
X
